PMDG737 won't start with PMsystems
I'm talking to PM support about this - but just wondered if any of you have struck the same problem....
I’ve been using PMsystems for a few months now without problems. Just in the past few days I cannot get an engine start with PMsystems. The N2 rises to 22%, fuel cutoff is brought to idle, but it will not start and the start valve just keeps cycling without success.
Everything is set properly – APU running, APU bleed on, packs off, valve open etc. However I’ve noticed that the duct pressure (in PMsystems) is very low .. only about 5-10%. The CFM56 needs 30% for a start as far as I know.
If I shutdown PMsystems I can then start successfully using an FS panel (on-screen). Note - the PMDG panel is competely disabled - so should be no conflicts there.
I’ve tried builds 94 and 98 with the same result. Also did an uninstall and reinstall of PM systems with no change.