Re: toggle switches to fs9
What you need is the FSUIPC offset value for the function you want to control. Then you just assign your switch to that offset to make it work.
Re: toggle switches to fs9
how do i find that? also where do i assign it to the switch?
I am totally new to all this
ps thanks for your reply
Re: toggle switches to fs9
Actually, I think with Level D it isn't as easy as just assigning - if I remember properly. Some programs like Level D and PMDG don't provide the offsets. Go to www.lekseecon.nl and www.mycockpit.org/forums/showthread.php?p=34549 for the Level D solution.
Re: toggle switches to fs9
Hi,
You can use my free FSCONV program, it provides lots of FSUIPC offsets for the Level-D 767. The light controls are described in section 3.2, 3.3 and 3.4 of the Manual.
Register to my forum first and download from there.
Re: toggle switches to fs9
hi niko i presume, i tried using your product but couldn't find any step by step instructions for doing it, i looked at the manual but couldn't figure it out.
Re: toggle switches to fs9
Hi,
Everything as far as FCONV is concerned is in the Manual. You have to use FSConvigurator to activate the offset with the bits that control the lights first.
Then you have do 'something' with the software of your interface card to set/release the right bits in this FSUIPC offset when toggling a switch.
Re: toggle switches to fs9
RX5c71540*X83cc
is this the code for a leveld light switch?
how do i then assign this to my toggle switch as leo's board doesn't have any software
Re: toggle switches to fs9
Quote:
Originally Posted by
smartarze
RX5c71540*X83cc
is this the code for a leveld light switch?
? don't know what you mean by that.... but the lights switches in FSCONV are defined in section 3.2, 3.3 and 3.4 of the FSCONV Manual.
There is a distinction in lights buttons, and lights switches. For the switches you have a choice in using buttons (toggle versions) or using on/off switches.
A lights switch in the Level-D is controlled by setting/clearing a bit in one of the corresponding FSUIPC offsets at bytes 0x8B34, 0x8B35, 0x8B36 and 0x8B37
Quote:
Originally Posted by
smartarze
how do i then assign this to my toggle switch as leo's board doesn't have any software
Don't know leo's board, you better ask him... How does one normally activate a bit in a fsuipc offset with leo's board? If that is not possible it is pretty useless... imho
Re: toggle switches to fs9
thanks, I understand that the details for the lights are in the manual but for someone who hasn't a clue where to start there is no other details, i've been researching this for over a week and i'm still no closer to getting a switch assigned.