After painting I had troubles placing it back at real excact
for milling the text.
This is what I did with my last panels:
-saving the holes in the panel corner in a seperate file
-after painting, on a flattened mdf board on top of the bed I milled the corner holes into the mdf
-I mount the panel with these holes.
on my "cheap" table I got far better results with a flattened mdf bed,
a 0.1 mm. height fault is no problem with cutting out, but with bevels
and text-milling the table height tolerance should be better than 0.1 mm I think.
doing text with 0.25 mm. 30 deg. 50% overlap works for me.
hitting the acryl to deep gave bad results, it looks like the edges become unsharp
from acryl dust hitting (the side of) the paint.
this new 'due to simpitting hobby' is getting better all the time ;)