Hi,
maybe I have overread it but what are the Offsets for: - 7Segment Radiodisplay(COM1/Active/Standby); Switch for that; Encoders; Off/On Switch.
Thanks
Niklas
Printable View
Hi,
maybe I have overread it but what are the Offsets for: - 7Segment Radiodisplay(COM1/Active/Standby); Switch for that; Encoders; Off/On Switch.
Thanks
Niklas
Or are this the normal FSUIPC offsets?
No one?
ok. Since there are no answers I will form the question in a new way: When you are flying online how do you switch the frequency?
My guess is it depends on how you are interfacing and what hardware/software you are using.
If you have opencockpit hardware you can use their software and it will directly communicate with FSX/P3D.
normally I have OC, but this time I use Arduino. There the programm works with FSUIPC Offsets.
But I am not sure what offset is the right for JL software.
To make it clear: I mean the offsets of the RMPs
Do you have this ?
http://www.jeehell.org/Offsets.pdf
I know this, but unfortunatly there arenīt any information about the RMPs.
I've made it with SIOC. Use the sioc-creator to create an SIOC-script with the RMP-variable. Then put the variable to an offset.
Its realy simple an it works for me perfectly with an Arduino.
Sounds very interesting! You have a PM
Having the same challenge.
I use an arcaze board and mobiflight for output of the frequency.
But do not know how to change the frequency with my encoder (no p&p radio module, just the encoder in a selfmade panel)
Can I also use Sioc creator for that?
Thanks,
Michael