Hahaha, yammy parts, sarap :D
Printable View
Hahaha, yammy parts, sarap :D
Wasssup Makoy? hahaha
10 min of CAD time
5 min of cut time
45 min to fry lumpia
Here is my fast-track prototyping.
http://i1221.photobucket.com/albums/...c/DSCN2749.jpg
Coming up
HSI, AIS and Bezel with ATTITUDE.
Sorry for the crappy picture.
Attachment 6868
When will these bezels be available?
What type of monitors are you going to use? I am assuming you are going to use two for your Cessna 172 panel? I am interested to see if you keep the yoke placement scale or lower it to accommodate one screen. I have been struggling with this for some time now.
orange= monitor
blue=panel overlay
green=yoke
http://i1221.photobucket.com/albums/...ypic/panel.jpg
I'm constructing my own yoke. Typically, the hole for the shaft is on the center of the console , I placed it on the right side instead.
As for the monitors this is what I do for a living
http://www.mycockpit.org/forums/off-...tors-sale.html
I got hundreds of them to play with =] from 3.5 to 42 inch monitors i got them all. I'll keep you guys updated soon as I figure out which monitors I will be using.
My son engraved these knobs
http://i1221.photobucket.com/albums/...c/DSCN2974.jpg
Can you explain how you are going to get your gauges on those two monitors? Are you going to use fs panel studio to do it or some other way. I am very confused on how to do this. If you buy the project magenta ga fir panel can you place the gauges or do you have to cut out the proper size hole and go with their gauge setup? What is the best approach to getting gauges on those two monitors?