sort of yes & no, i did finally get the engines started but then pack 2 went into fault mode whilst airborne???? Will have to investigate further :-(
Michael
Printable View
sort of yes & no, i did finally get the engines started but then pack 2 went into fault mode whilst airborne???? Will have to investigate further :-(
Michael
Sounds to me like you have something else interacting with the PMSystems software. What AC model are you using?
An A320-200 i grabbed of flightsim.com
Michael
Yeah the one here to help you is Bob cause I have no idea how PM systems work!
Regards,
Roberto
Roberto, problem is now really solved. There was a problem with my startup procedure. Thanks for your help.
Michael
That is great news buddy!! What happened??
Take care,
Roberto
The reason for No.2 not starting was after i started no.1 The xbleed was not open!!!
Below is the new checklist....does this look right Roberto?
"short" Checklist for engine start
- Battery ---------- ON
- Parkbrake ------ Set
- EXT PWR ------ ON
- Fuel Pumps --- ON
- APU Master --- ON
- APU Start ------ ON
- Pack 1&2 ------- OFF
- APU Gen ------- ON (when "AVAIL")
- BUS TIE -------- ON
- APU Bleed ----- ON
- EXT PWR ------- OFF
--- Eng 1 Start
--- ENG 1 --------- ON
--- IGN / START
------ CROSSBLEED -------- AUTO or OPEN !!!!!!
------ Eng 2 Start
------ ENG 1 ------------ ON
------ IGN / START
...
Michael