Cheers Simon, will try. :cool:
http://www.mycockpit.org/forums/atta...id=11481&stc=1
Printable View
Cheers Simon, will try. :cool:
http://www.mycockpit.org/forums/atta...id=11481&stc=1
Looking great Ben...
Good luck on your conversion and keep us update. ;-)
Looking great and good to know that it works without cutting them :)
Good luck and have fun with it. Nothing else is as good as a real throttle of all the parts in the sim.
Throttle lever pot has been wired for further testing -- no wires were cut. Thank you Simon!
https://www.youtube.com/watch?v=aHtUwVlOiuU
wow you made it !! Great Job Ben ...Make sure the noise from the TQ dont wake up your wife :roll:
Lol, I think it will take me awhile to figure out SIOC and how to interface it with FMGS, so she can count her blessings :)
Great Work! :) :)
Back light of the throttle and trim is now complete -- however strangely enough only the bottom half lights up.
Not too sure if the top bulbs are all blown -- still trying to determine if there is additional wiring required.
http://www.mycockpit.org/forums/atta...id=11494&stc=1
Hi,
I am sure lamps are out, the throttle light plate uses 12 miniature lamps T1 (ms24367-715) 5V, 0.115A. You can measure the current at 5V and with anything less than 1.38A you can assume how many lamps are out... and then soldering follows!
Regards,
Simon