-
Re: Round bottom
Maybe I can give a contribution to bended/round shaping.
At almost all good homeinprovement stores there is bendable playwood for sale. This plywood comes at 1/4" (6mm) thicknes.
Usually the plywood layers are cross grained for strength wich makes it hard to bend it on a small radius.... bendable plywood is long-grained.
http://www.revaservice.nl/Pics/Generic_Cessna_07s.jpg
http://www.revaservice.nl/Pics/Generic_Cessna_03s.jpg
http://www.revaservice.nl/Pics/Generic_Cessna_05s.jpg
This plywood is cheap. A whole plate (244 x 122 cm .... aprox 8 x 4 ft) will cost you about Euro 35 .... $42
Kind regards, Nico
-
Re: Round bottom
Thanks for that info, ... I think I have to visit Gamma tomorrow anyway!
That's a darned nice looking stand/rig you have made there, .. really looking great!
-
Re: Round bottom
Sorry... not Gamma... but a larger Praxis would have it in store
(Dutch insiders only)
Nico
-
Re: Round bottom
< dutch insider mode on >
That's interesting to know, we have three Praxis here in Almere, the two larger ones are the Praxis at Doemere and the Praxis megastore in Almere-Stad. I have always believed that Gamma has a better selection of wood than Praxis does.
I have to go and investigate tomorrow :)
< dutch insider mode off >
-
Re: Round bottom
Robert (AKA Kinsky) has done a tutorial already. Including saw scheme and all measurements.
http://www.mycockpit.org/tutorials/showentry.php?e=41
-
Re: Round bottom
Here's the finished result. We only have to paint the metal strip. It's getting realistic - I have trouble getting in the seat :roll:. Next project: J-rails I'm afraid.
http://www.mycockpit.org/photopost/d...0/IMG_3464.JPG
http://www.mycockpit.org/photopost/d...0/IMG_3462.JPG
edit - I meant to reply to my first post but I struggle with the new forum interface