Movement of Flaps Gauge Problem
I know this is a documented issue from Project Magenta but I don't seem to be getting anywhere.
The problem is I'm getting the needle moving 3 postions between "0" and "1" on the gauge and it skips position "10" and "30". Has anyone had this issue?
I have directed all the PFD ini files "Type" & "AircraftType" to equal "CDU". I am using the "737-800 V4" Aircraft Configuration File from the PM website.
If anyone could enlighten me, it would be much appreciated.
Perhaps you can find the answer here.
I discussed that on my website too:
scroll a bit down and you will see.
By davemckee in forum General Builder Questions All Aircraft Types
Last Post: 05-07-2010, 05:36 PM
By jackel902 in forum Cockpit Parts and Motion Platforms
Last Post: 04-23-2010, 06:39 PM
By dimon2kgb in forum I/O Interfacing Hardware and Software
Last Post: 11-26-2008, 03:48 AM
By Jackpilot in forum General Builder Questions All Aircraft Types
Last Post: 07-15-2008, 01:09 PM
By B738 in forum PM General Q & A
Last Post: 04-14-2008, 02:55 PM
Search Engine Friendly URLs by vBSEO