PDA

View Full Version : Gear instructions



michelmvd
03-05-2007, 05:41 AM
Hello,
I'm looking for the instruction you have to put in FS2Phidget (equal to "G" keystroke). Which offset can I use to activate single switch ?
Many thanks for most appreciated help
Michel

PeterH
03-05-2007, 08:38 AM
Hi Michel,

the FS offset: for Gear up dec. 66079 = hex 1021F
for Gear down dec. 66080 = hex 10220

Hope this is what you are after

Best rgds

Peter

michelmvd
03-05-2007, 04:59 PM
Thanks a lot then it looks that I will need to swiches in the gear box
Greetings
Michel

Bob Reed
03-05-2007, 05:06 PM
You could use one offset for when the switch is on and the other for when the switch is off. That would give you your 2 offsets as well.

michelmvd
03-06-2007, 04:04 PM
Hi Bob, hmmmm can this be done with FS2Phidget ?
B. Rgds
Michel

alandyer
03-09-2007, 10:22 PM
Michel,

One offset (gear handle).

Two Values for Offset (gear up and gear down).

One switch with two Values (on and off).

Use Fs2Phidget (or any solution supporting Digital Input) to:
assign Gear up Offset value to a switch's Off position
assign Gear down Offset value to a switch's On position.

Gear Offset: 0BE8
Offset values: 0 = Up, 16383 = Down

Regards,
Alan.

michelmvd
03-14-2007, 09:19 AM
Okidoki Alan, its is working.
Many thanks for your super support.
Ciao
Michel