737 trim wheels

[DCO]

Hi,

I would like to connect the 737 trim wheels to a motor to make them move along with the electronic trim on the yoke. Has anybody a setup for this, that would be a good lead for me as I am not into electronics (yet) :)

Thanks,

Marnix
www.dreamflight-cockpit.be

[mauriceb]

This is how I did it. Works great but the only big problem for me was finding DC motors small enough to fit in a 737 throttle assembly. I found some but the mechanical linkage was very poor, so I'm redoing it with some new motors I found. The electronic part worked flawlessly though.

Hope this helps,
Maurice

http://i32.photobucket.com/albums/d38/mau_ben/StabilizerTrimMotorsWiring-v3.jpg