Keystrokes and bitmaps ?

[imported_redman]

Hi Alan,
Great work with 3.1

I am having problems saving a bitmap greater than 8. If i change it to anything above 8 and save it, it does not recognise the bitmap from FS. When i reopen it to edit, it has reset to 8.

I have also read the doc, and haven't been able to find where to enter keystokes to be sent to FS.

Once again, I appreciate all your effort

Best Regards
Chris G.

[alandyer]

What offset are you using that has length greater than 8 ?

[alandyer]

Chris,

Look at table of contents (page 2)
Chapter 6 Digital Input - Keystroke Emulation.

What page number do you see for that in your documentation ?

Regards,
Alan.

[imported_redman]

Hi Alan,
:o
OK. I was looking at the word doc, and not the pdf. The pdf has the line about keystroke emulation. For someonw who works in the software industry, I am feeling like a real dolt.
Ok. So I key in KEYSEND in the FS Variable, under my variables. It is expecting an offset of some sort there (you can't leave it blank, etc) and I tried with many different ones. I cannot get the calibrate button to highlight. Selecting each of the types of FS Values, didn't seem to make a difference either.


In regards to offsets, for example : using 04F2 I need from B0 to B10 (i.e. B10 = EEC right switch)

thanks for you patience. ;)

Cheers
Chris G.

[alandyer]

KEYSEND is supplied ready to go in FS2PhUIPC310.ini

[alandyer]

The problem with bit being reset to 8 has been corrected for 3.1.1

[imported_redman]

Thanks Alan,

For some reason the 310.ini file wasn't getting installed into my variables directory.
I looked in the cab file and found it there.

Thanks a lot.

Chris G