PDA

View Full Version : FSUIPC Offset for Radio Control



Niklas
06-17-2016, 01:41 PM
Hi,

maybe I have overread it but what are the Offsets for: - 7Segment Radiodisplay(COM1/Active/Standby); Switch for that; Encoders; Off/On Switch.

Thanks

Niklas

Niklas
06-21-2016, 02:41 AM
Or are this the normal FSUIPC offsets?
No one?

Niklas
07-01-2016, 10:00 AM
ok. Since there are no answers I will form the question in a new way: When you are flying online how do you switch the frequency?

OmniAtlas
07-02-2016, 06:44 AM
My guess is it depends on how you are interfacing and what hardware/software you are using.

If you have opencockpit hardware you can use their software and it will directly communicate with FSX/P3D.

Niklas
07-02-2016, 11:04 AM
normally I have OC, but this time I use Arduino. There the programm works with FSUIPC Offsets.
But I am not sure what offset is the right for JL software.

To make it clear: I mean the offsets of the RMPs

asessa
07-04-2016, 08:56 AM
normally I have OC, but this time I use Arduino. There the programm works with FSUIPC Offsets.
But I am not sure what offset is the right for JL software.

To make it clear: I mean the offsets of the RMPs

Do you have this ?
http://www.jeehell.org/Offsets.pdf

Niklas
07-04-2016, 11:03 AM
I know this, but unfortunatly there arenīt any information about the RMPs.

Beret
07-04-2016, 04:15 PM
I've made it with SIOC. Use the sioc-creator to create an SIOC-script with the RMP-variable. Then put the variable to an offset.
Its realy simple an it works for me perfectly with an Arduino.

Niklas
07-05-2016, 10:12 AM
Sounds very interesting! You have a PM

michael1508
07-09-2016, 11:38 AM
Having the same challenge.
I use an arcaze board and mobiflight for output of the frequency.
But do not know how to change the frequency with my encoder (no p&p radio module, just the encoder in a selfmade panel)

Can I also use Sioc creator for that?

Thanks,
Michael