PDA

View Full Version : V/S-Mode and IAS-Hold



manuelthomi
10-26-2014, 12:01 PM
Hy

I have some problems during approach when I fly in ias-hold-mode and engage the v/s-mode. After that the autopilot doesn't hold the speed correct, starts accellerating and I have to engage the open descent mode to maintain the speed.

Does anybody have a idea what I am doing wrong?

Regards
Manuel

jeehell
10-30-2014, 06:31 AM
Hi,

VS mode means a fixed rate of descent. If it's too steep, your engines go to idle, and eventually you will accelerate again if the slope is really too steep. YOu need to have flaps out and slow down before starting the descent. On an ILS at 3 slope, the aircraft cannot reduce below 200 kts without any flaps.

JL

manuelthomi
11-02-2014, 01:42 PM
Dear JH

Thank you for your answer and by the way for this wonderful product.

I just did two flight. On the first I didn't have problems, the airplane behaved like I would expect it to do when I change to v/s-mode und try to decelerate to around 180 knots while I'm descending with a vertical speed of 1000 ft/min to the final approach altitude. On the second, I had the mentioned problem again, but just for some seconds. It seemed to me, that there were some strange winds that caused the problem. I'm using FS Real Weather.

I have to add to my first post, that the engine should stay in idle, but they don't. The N1 spools up to around 45%. The transient N1 shows that the engine should go to idle but they don't.

Best regards
Manuel

manuelthomi
11-24-2014, 09:19 AM
Dear JL

I just had a similar situation on a flight to Vienna. There was tailwind of about 12 knots and I had ias-hold-mode on with 200 knots. But the plane didn't maintain 200 knots, the speed tape showed a speed between 210 and 220 knots. It looks like to me, that the tailwind was just added to to speed flown.

The ias-mode should maintain 200 knots regardless of having a tailwind component. Or am I wrong? Am I the only person facing this situation?

Regards
Manuel