View Full Version : Altitude set

04-04-2014, 05:13 AM
Hi all,

I am after a litte advice, how would I go about getting the autopilot atitude read outs to a LCD screen, I have wired up the radio panel, so I presume I can use that set up but the code is confusing me a little!

Any help would be great!



04-04-2014, 10:31 PM
Hello drury,
You're correct; it is similar.
1.) Pay attention to the identifier i.e., "=", "<", ">", etc.;
2.) Take note of the amount characters sent from L2FS to the arduino; this is can be determined by connecting L2FS to FS9/FSX and checking the box for the appropriate data to be sent.

If you continue to have difficulty, post your code; there are many in this forum who will be happy to help you along.