PDA

View Full Version : APU Procedure stops at "Flap open"



pmartin
02-12-2014, 04:20 PM
Hello guys!
I installed the FS X, the Jeehell-Soft and an configure a throttle and a joystick!
After this i start the "StarterFSX".
Everything is working until the position "APU-Start".
After i start the APU with "APU-Master" after this "APU-Start".
I see on the SD the APU page. I see the message "Flap open" but the "N" and "EGT" are not starting.

I hope anyone know the problem why the APU-procedure stops!

regards
Peter

jeehell
02-12-2014, 06:02 PM
Hi,

You did not pause FSX?

Regards,
JL

pmartin
02-13-2014, 12:01 AM
hello jl!
No not paused!
regards peter

OmniAtlas
02-13-2014, 01:45 AM
Did you start the ab flyby wire exe (can't remember the exact file name)?

pmartin
02-13-2014, 04:44 AM
Hello guys!
I found the problem!
At first i had to say i installed all Soft (FSX an Jeehell) on one Laptop for a test configuration.
And the problem of this Laptop is, that i see the last line of the fsx-window not!
So the cracks know whats happend :-))
I forgot to unmark at the FSX config that he "pause" if i leave the fsx window!
After this my software is working (means the apu starts and the start-button shows "avail" etc.)
Thanks for helping anyone!
regards peter