PDA

View Full Version : Route not displayed on ND after new installation



Space
11-24-2013, 02:08 PM
Hi,
i am using the B30 Version. I installed a new Client in my network to Display only PFD and ND for the captains Side. I used the normal installer. I have now the Problem, that the programmed Route from the MCDU is not visiable. Client is connected correctly to the Server. I can see waypoints Airport etc, choosen by EFIS. Aircraft is following the Route, but it is not displayed.




http://s14.directupload.net/images/131122/zumr7nuv.jpg
http://s7.directupload.net/images/131122/s4aa76ql.jpg


Here are pics from PFD and ND and MCDU.


Any help would be welcome.


Thanks in advance!


Andy

prinwibowo
11-27-2013, 06:12 AM
Hi,

I am using the lastest version of FMGS. I installed and run it. after that I tried to run MCDU client. FMGS server can detect and be connected to MCDU Client, and also connect to FSX well, for networking is OK, but the problem is that MCDU Client still did not come alive, just black screen (nothing written on display). any missing procedure I took? pls give me suggestion to make it alive.

any help would be welcome

I'm looking forward to hear from you.

best regard

Space
11-27-2013, 07:09 AM
That is not the answere of my thread:(

jeehell
11-27-2013, 07:20 AM
@Space, you posted this message twice, did you see the answer on the other thread? http://www.mycockpit.org/forums/showthread.php?t=27059

@Prinwibowo: did you start the engines or EXT PWR?

JL

prinwibowo
12-05-2013, 07:29 PM
Hi JL,

I was creating a application to access FSUIPC offset of MCDU (0x78EC). but the offset always display 0, nothing happened. the whole offset you prepared in User Guide.pdf is also not working. I'm using FSUIPC ver 4.9 and FMGS successes to connect FSX and run well. My application had been tested with other offsets (not your offset table) and run well.

any sugesstion

thank you

jeehell
12-05-2013, 07:38 PM
Hello,

I've just tested right now, the offset 0x78EC works correctly, as advertised.

Regards

prinwibowo
12-05-2013, 08:17 PM
Hello,

I've just tested right now, the offset 0x78EC works correctly, as advertised.

Regards

How do you do that?. any steps I should do to make it works?

Regards.