PDA

View Full Version : Yoke pots to BU0836x ports



nax228
01-07-2011, 09:55 AM
Witch ports in the Leobodnar BU0836x shall I connect my two yoke potmeters to?
I have done a few searches, but can't seem to find a 100% answer, and I want to do it right the first time.

Atomic_Sheep
01-07-2011, 10:15 AM
Have a read of my thread... I believe the answer you seek is in one of the replies.

http://www.mycockpit.org/forums/showthread.php/21878-Electronics-Noob-Button-Help?highlight=

ian@737ng.co.uk
01-07-2011, 12:01 PM
hello nax.......
connect the yoke axes to the X axis & Y axis inputs to the card. this will allow you to set the 'centred' position in the windows calibration page in the control panel.
makes life very easy. then if you have a registered version of FSUIPC, you can tweak the inputs and the response curve in there.
hope that helped you out captain......
regards from wales...

ian

nax228
01-07-2011, 12:58 PM
Ta Daaa

Solved

Thanks a lot guys