View Full Version : Simkits APU Gauge and PM

Joe Lavery
05-16-2010, 10:52 AM
Hi Guys,

I recently installed a Simkits APU ETG gauge but it doesn't follow the graphic is the PM systems program. In fact it simply goes from 0 straight to 10 as soon as the physical switch is operated.

I'm using the FDS SYS 1 card for interfacing my overhead but whatever settings I use the gauge does the same. When I switch off the APU the Simkits gauge doesn't move until the PM System gauge reaches zero, then it returns immediately to zero as well. :sad:

Any thought would be appreciated,


05-16-2010, 12:28 PM
Hi Joe,
are u using an usb or the std for the CCU,

Joe Lavery
05-16-2010, 12:37 PM
Hi Kermit,

It's a USB Gauge. It calibrates fine but doesn't follow the PM System graphic gauge. It's almost as if it's reacting to a switch on/off command.
I wondered if it was a problem with the XML code I've used.