PDA

View Full Version : GC Startup



vybhav
01-30-2010, 08:10 AM
Dear All

Everytime GC starts it goes through a routine and checks and confirms the open GL configuration before it commences the saved screen.

Is there any method by which I can make GC to stop this start up routine?

l_loupias
01-30-2010, 03:13 PM
Hallo Vybhav,

I think you mean that you do not want the benchmark to be run every time you start up the GC?

If this is so, you just have to change the "Benchmark=On" to "Benchmark=Off" in your PFD.INI file where you installed the GC software. (Most likely in C:\PFD).

I hope my answer helps you!

With kind regards,

Lefranc Loupias

farrokh747
04-07-2010, 11:42 PM
hi -

As far as I know, The benchmark test will run only if GC/WideFS does not detect FS running = if FS is running and Widefs is config ok, PM GC will go directly to the last PFD/ND/EICAS combo....

fc