PDA

View Full Version : Servo Cards Help



No Longer Active
10-29-2009, 07:47 AM
Will the open cockpits servo card be capable of controlling both micro servo's aswell as normal servo's. Just that I actually have 4 micro servo's in an old RC plane that I used to fly and was wondering if I could use them instead to save some money.

Thank you.

Alex

fordgt40
10-29-2009, 10:25 AM
Alex

I use Hitec HS-55 servos which are a fraction of the size of a standard Futaba servo. They work fine on the OC servo board.

Regards

David

No Longer Active
10-29-2009, 10:32 AM
Super, thats another 2 gauges I can get on with now!

Could you tell me also where to get gears from, as instruments like the ASI
will be run on unmodified servos...I am assuming you can do this?


Cheers David....

I am sure we will talk again real soon....

:)

fordgt40
10-29-2009, 11:08 AM
Hi Alex

Here you go:-

http://www.technobots.co.uk/acatalog/Online_Catalogue_MOD_0_5_Plastic_Spur_Gears_398.html

The Mod 0.5 size gears are the ones you need.

Regards

David

Kerbo
10-29-2009, 11:09 AM
I bought gears from Serv-O-Link (http://www.servolink.com/) for the instruments I am building. They might have something that will work for you.

No Longer Active
10-29-2009, 11:18 AM
Cheers alot guys....

I think I will buy a selection pack and work out what I can achieve.

I need to convert 180 degree movement to about a 300 degree movement.

So I am assuming a large cog on the servo to a small cog on the needle!

Cheers guys!

Alex

No Longer Active
10-29-2009, 12:13 PM
So the asi is something like this from looking at measurements and pictures, I have got to this stage:

http://alexpilot.50g.com/make%20asi.jpg

This is using an unmodified servo HS-55

EDIT: How do you calculate the number of teeth required or do you just buy selection packs and
play around until you get the right movements?

RE-EDIT: I fully understand that I need to do some research on gear ratio!!!

Cheers.

Alex

fordgt40
10-29-2009, 12:36 PM
Alex

Its not rocket science - just count the teeth. So for your example you need double the teeth on the servo as opposed to the gear on the ASI needle. It is always a good idea to have some extra movement in hand as some servos can get a bit jittery when you need to move them to their extreme positions

Regards

David

No Longer Active
10-29-2009, 12:40 PM
It certainly isnt rocket science when you explain things! lol....

Cheers David...I will post my progress shortly...!

Alex

tomenglish2000
10-29-2009, 01:02 PM
That technobots website is perfect for me! Everything I need for custom gauges! Thanks David

fordgt40
10-29-2009, 04:30 PM
Alex, Tom

Another site with a different range of 0.5 MOD gears. They also have toothed pulleys and belts which I shall be using to convert my Simulatory servo driven 737 Throttle assembly into being powered by DC motors.

Regards

David

http://www.motionco.co.uk/spur-gears-spur-gears-c-32_33_34.html