View Full Version : TQ simulatory issue

10-08-2009, 01:41 PM
Hi to all.

I've just bought a TQ Simulatory from a my friend. I changed the Fsbus interface with the Leo Bodnar interface to better use with Fsuipc. But I have a problem with the Thrust lever N2 potentiometer. It give not smooth value like the N1.
exemple: In Fsuipc calibration page, I see values change from -16383 to 0 suddenly with no intermediate values like the potentiometer for thrust N1.

Do you know how to disassembly the TQ in order to change the potentiometer?

Many thanks and sorry for my bad english.

Arnaldo Vacca

10-08-2009, 05:42 PM
I shall watch this thread with interest as I need to do this too :-(
Was it easy to remove fsbus and replace with the Leo card?


10-09-2009, 02:18 AM
it's not difficult if you have 16 pin IDC plug connecting the switches & pots to your control board. there's a wiring diagram on my website and if you need, i'll walk you thru it.
i've done it a couple of times for colleagues.

rgds ... ian