Problem: uncontrolled Power input from AT with LVL mode

[Jan Pemöller]

Hello,

since the last builds I have some new problems when switching to LVL-Change. Sometimes the AT trust increases without any reason (during descent). Yesterday two times when AT was off and I switched LCL CH on, the turned off AT increases the trust.

Does anyone have same problems?
I will get into this deeper later and will report to PM, but other opinions from other users are very welcome.

regards
Jan

[Jan Pemöller]

Problem seems to be history after last builds ...

[autocadplease]

I get weird AT behavour sometimes too. Sometimes even on only one engine.