PDA

View Full Version : Part instalation of PM with FS9 & PMDG



Daveanne
03-11-2009, 07:30 AM
Could anyone help?

I have a simpit XP, FS2004, (PMDG 737-800) and all is working fine at present, I was looking at the overhead guages that can be purchased from various departments and became quite exited that they could all be daisy-chained and work from one controller board, yes the adds said that it interfaces with Fs 2004 too!

Great, but in very small writing at the bottom of the add it says "must have PM software installed".........mmmm new there would be a catch!

I undersatnd that PM is supplied in modular form (please correct me if I am wrong), if so can just the Overhead module be purchased in order top run the various guages without interfearing with anything else?

I know the probable answer will be........eerrrrr NO.

Any help/tips/pointers would be appreciated.

Daveanne

Jackpilot
03-11-2009, 08:57 AM
Try the PMSystem demo . It's free.
Should/could work, partially at least.
It will interact with FS only.
Besides PMSystem(as far as I know because I tried it but do not use it) is very flexible and can be edited if you are better than I am with software.

Try the Demo.
Jack

Jackpilot
03-11-2009, 09:34 AM
Check this old post.
Video on page 5
http://www.mycockpit.org/forums/showthread.php?t=13213