PDA

View Full Version : RAL7043 Paint UK



droddis
04-07-2008, 03:03 PM
Does anyone know where i can buy RAL7043 in the uk, or delivers to the uK, to make my panels. I cannot for the life of me find it anywhere.

Thank
David

Holclo
04-07-2008, 03:10 PM
B and Q mix RAL colours. I used RAL7011 in my cockpit. Had it mixed in my local B&Q. Get a tester pot mixed first (about £2)
Bill

phil744
04-07-2008, 05:38 PM
Just go to a local car paint specialist like autopaint international or parrys, there should be someone local to you.

I went on Friday and picked up some boeing brown and RAL7011 to test a few panels ive made. (which are awsome!!)

Failing that, let me know your location and i will find someone near you, if not i can send some to you

Induced_Drag
04-08-2008, 04:56 AM
While on the subject of paint.

What is the RAL no. for the 737NG grey ?

Regards,
ID.

phil744
04-08-2008, 06:01 AM
the RAL fot the panels is 7011, looks good to me

Induced_Drag
04-08-2008, 06:36 AM
Thanks Phil,

Regards,
ID.

droddis
04-08-2008, 10:20 AM
I am going to use

RAL7043 for the dark grey panels on the 737.

and

RAL7040 for the light grey panels on the 737.

This is what hispapanels are using so i assume its close.

Thanks
David

makoy
04-09-2008, 01:38 AM
Just go to a local car paint specialist like autopaint international or parrys, there should be someone local to you.

I went on Friday and picked up some boeing brown and RAL7011 to test a few panels ive made. (which are awsome!!)

Failing that, let me know your location and i will find someone near you, if not i can send some to you

Hi Phil,

Is that RAL 7011, brown color to panel's of 747 and 777?
What about that dark brown color?
I have some part's ready to paint, just looking right color's to finish it.


Marco
B777

Holclo
04-09-2008, 04:19 AM
No Marco Ral 7011 is dark grey. Don't know the "brown number" but someone will be along shortly with it.
Bill

phil744
04-09-2008, 08:24 AM
Ok,

I have been told that the blue/grey used on 737 stuff and old boeings is RAL7011.

For a bit of fun I decided to order some 7011 paint and have a go at making a few panels for the 737, the photo below is one of my panels done in 7011 laid across a real 737 part (keep in mind its an old panel, probably 15+ years old). I have to admit it is very close, however to match the real part 7011 needs to be a little darker, however the blue content is spot on. Another thing you should know is that i have several real 737 pieces, when all put together not a single piece match, this is even worse on the Boeing brown panels, the difference in colour between each panel (and even from the same panel supplier) is quite frankly staggering.

http://i17.photobucket.com/albums/b52/madmini1/DSCF3559.jpg

All i know with the Boeing brown (light brown used on panels) is boeings own spec 8328, testors #2008 RAW (information used from Mikes flightdeck http://www.mikesflightdeck.com/center_pedestal_4.htm ) however i could not find any reference to it here, so I took a selection of real panels and had there colour matched.

Holclo
04-09-2008, 08:43 AM
Phil 744 - your panels are simply amazing - many congratulations. I found tha a light coat of clear varnish darkened down the RAL 7011(emulsion) just a little.
Bill

phil744
04-09-2008, 01:01 PM
Cheers!!

Its hard to tell by the photo below but the panel at the bottom has has a satin clear coat, when you look at them in the flesh is is slightly darker, but it funny, with boeing brown the clear coat makes them lighter.

http://i17.photobucket.com/albums/b52/madmini1/new-1.jpg