View Full Version : Building a Yoke

cpt kaneo
10-27-2007, 08:03 AM
Does anyone have any experience in making Yokes because I am looking for a circuit diagram of the electronics needed.

Any information would be greatly appreciated

thanks in advance


Michael Carter
10-27-2007, 10:07 AM
There are four switches on a Boeing yoke. Dual momentary trim switches (ON) OFF (ON), A single momentary pushbutton NC switch for the AP disconnect, and a momentary NO PTT switch. They are wired the same as any other simple switch.

Here is the schematic for the trim switches:


cpt kaneo
10-27-2007, 10:38 PM
thanks a lot!

10-28-2007, 05:40 AM
Hi Kane, my 737 yokes are homemade, there are heaps of pics in my gallery!


cpt kaneo
10-29-2007, 02:06 AM
Thanks Gwyn, I'll make sure that I check them out